Table of Contents
The article explains how to To replace Laptop the battery on the PC. Chemical energy is the type of energy that laptop battery store. We will see the basic procedures for changing a laptop battery with you. We’ll go over everything, including the tools you need and the correct way to change your old battery. Follow the steps are given below.
Nothing directly affects how long your computer lasts longer than its battery. When your laptop battery life is significantly shorter than when it was new, it’s time to replace it. Your laptop’s lithium-ion battery ages and becomes less effective over time. Also, insufficient power can affect overall performance and operating time as power-hungry components such as the processor and graphics card cannot function effectively. Allowing your battery to drain to the point where not even your laptop fans are able to draw enough power to reduce high temperatures, which can permanently damage your components. Here is the article Identify and Replace a Dead Laptop Drums.
3 ways to replace Laptop Battery in the computer
Changing a removable Laptop Drums
Step 1: Buy a replacement battery. You need to know the make and model of your laptop to buy the correct battery. You may even want to remove the battery and verify that it has a model and/or part number written on the battery.
Step 2: turn off your Laptop. You can press and hold the power button On your laptop or use the following steps to turn off your laptop:
Step 3: Unplug the AC adaptor. Unplug the AC adapter from your laptop to disconnect the laptop of the AC adapter.
Step 4: transform your laptop and locate the battery. On most laptops, the battery can be found at the bottom of the laptop along the back.
Step 5: Slide and hold the battery release latch. The majority laptops It has a release latch that you slide and hold to release the battery. Any laptops It has two release latches that you slide and hold at the same time. Other laptops may have a separate latch switch that you need to slide to unlock before sliding the release latch. Some older models have a latch that you pull out and push towards the battery. In rare cases, the battery can be screwed in and require a screwdriver to remove it.
Step 6: Insert the new battery. After removing the old battery, insert the new battery exactly as the old one came out. It may be necessary to slide the release latch or disengage the lock switch to slide it back.
Step 7: block the drums at the place. The majority laptop the batteries fit themselves. On some computers, you may need to slide the lock switch to lock the laptop battery in place. If you have screws, you will need to use a screwdriver to screw the screws back into place.
Step 8: reconnect the CA adapter and let the battery charge. Plug the AC adapter into an electrical outlet, then plug it back into the laptop to allow the battery to start charging. Wait a few hours for the battery to charge. Once the battery is charged, you can turn on your laptop and resume use.
Changing a non-removable Laptop Drums
Step 1: Check if your laptop it’s under warranty. many younger laptops does not have removable batteries. You will need to remove the bottom panel of your laptop to access the battery. This will likely void any warranty you have with your laptop. if your laptop under warranty, go through the warranty process and have a professional technician replace the battery for you.
Step 2: Buy a replacement battery. You need to know the make and model of your laptop to buy the correct battery.
Step 3: Turn off your Laptop You can press and hold the power button On your laptop or use the following steps to turn off your laptop.
Step 4: Turn it around laptop over and remove the screws. Use an appropriately sized screwdriver to remove all screws holding the bottom panel of your laptop at the place. Some of the screws may be hidden under the rubber screw caps. If this is the case, use a safety pin to remove the screw caps.
Step 5: Use your fingernail or a plastic pry tool to detach the laptop bottom panel. Place your fingernail or plastic pry tool between the space between the bottom panel and the rest of the laptop. Go around the edges and gently release the back panel. You will need to use some force, but try to be as gentle as possible.
Step 6: Lift the bottom panel slowly. When the bottom panel is free, slowly lift it up to reveal the inside of the computer. There may be wires or cables connected from the bottom panel to the laptop’s motherboard. Be careful when lifting it.
Step 7: Disconnect any wires or cables connected to the computer. If there are cables or wires connected from the bottom panel to the computer, note where they are connected and carefully lift them up from the port to which they are connected.
Step 8: Locate the battery. The battery is usually a long black stripe on the back of the laptop. You can feel the battery rollers inside the battery film covers.
Step 9: Disconnect the wires connecting the battery. There is probably a set of wires coming from the battery and connected to the motherboard. lift gently up on the connector that is connecting the wires to the motherboard to disconnect the wires.
Step 10: Insert the new battery. After removing the old battery, insert a new battery exactly as the old battery was positioned. If there are screws holding it in place, be sure to replace them.
Step 11: Connect the battery to the computer. Use the connector that the battery wires are connected to to connect it to the same port that the old battery was connected to. Push the connector down so that it clicks into place.
Step 12: Reconnect all wires from the bottom panel to the computer. If there are any wires coming from the back panel, be sure to reconnect them to the same port it was disconnected from. Slide any ribbon cables back into their connecting devices and press the locking mechanism to lock it.
Step 1: Turn off the computer Press and hold the power button button on the computer tower or use the following steps to shut down the computer. If your computer is losing its date and time settings, or you get an error that says “CMOS Read Error”, “CMOS Checksum Error”, “CMOS Battery Failure”, “System Battery Voltage is low” when the computer boots up, it might be time to change the CMOS battery. You will see this error when the computer boots up.
Step 2: disconnect the computer. IIt is important that you disconnect your computer from any power source before working on your PC. Unplug the power cord from the AC outlet.
Step 3: remove your matecomputer side panel cover. It’s on the side of your computer tower. You may need a screwdriver to remove the side panel of your PC. This gives you access to the inside of the computer.
Conclusion
Here they are final from our article how to remove one Laptop Drums. We demand this every day because, because most of our computers are laptops, we use both in home and at school, where the batteries end up running out of power. Compared to the batteries that come with it, laptops often last much longer. Currently, most batteries will last two to four years with proper care. The article is now finished and you know how to to replace Laptop Battery cells.